If this machining center is used by someone else, ask them if they have adjusted the phase sequence of the forward and Custom automotive exterior Manufacturers reverse motor of the tool magazine without permission. The operator will use the reset button to change the calculation method, or simply press the emergency stop button. Try to let the machining center tool library itself complete the entire M6 cycle, so it will certainly not be messy.

When there is an alarmgive an alarm), see which signal in the T picture did not arrive or was caused by a flashing. Communicate with the manufacturer you purchased. How to deal with the chaotic tool in the tool magazine of the machining center: Another possibility is that the T-map is not rigorously authorized. After manual tool magazine reset (reset), tool magazine disorder may occur. Looking for a knife nearby, the tool library was messed up.

The tool change process is stuck due to insufficient tool change air pressure during normal tool change. In addition, after the tools are out of order, remember not to operate the operation panel keyboard of the machining center. This situation may be caused by a problem with the upper and lower processing ports of the machining center.

If the manufacturer has after-sales service or after-sales maintenance, you can ask their technicians to check the safety. If there is a high-low shift function, also check the low-high-low signal. If this is done, the tool magazine can only rotate in one direction, so it can’t. Check whether the counter switch is loose and whether there is any knife jamming.

Megosztás a facebookon